Uniden EXAI2248 series - Manual (Page 15)

[ 13 ]
GETTING ST
ARTED
G E T T I N G S T A R T E D
If your telephone outlet isn't
modular, contact your telephone
company for assistance.
Modular
5) Connect the telephone line cord to the TEL
LINE jack and a telephone outlet once the
handset is fully charged.
Mounting the Base Unit on a Wall
DO NOT use an AC
outlet controlled by a
wall switch.
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1) Plug the AC adapter to the DC IN 9V jack.
2) Wrap the AC adapter cord inside the molded wiring
channel as shown.
3) Plug the AC adapter into a standard 120V AC wall outlet.
4) Plug the telephone line cord into the TEL LINE jack.
Wrap the cord inside the molded wiring channel
as shown.
5) Plug the telephone line cord into the telephone outlet.
6) Raise the antenna to a vertical position.
7) Align the mounting slots on the base with the mounting
posts on the wall. Then push in and down until the
phone is firmly seated.
EXAI2248 2/8/2 7:05 PM Page 13