Universal Remote Control (URS) Thermostat THZ-100 - Manual (Page 20)

Page 20
THZ-100 T
HERMOSTAT
Selecting Hold for Time
If you desire to hold a particular desired temperature for a specific
period of time, use the arrow keys to move the highlight bar to Hold
for Time.
Press the key below the OK key label in the smart-key label at the
bottom right of the display to select this new mode. If you decide
to cancel the operation then press the key below the Go Back key
label in the smart-key label at the bottom left of the display.
If you select Hold for Time, the screen updates to the Set Hold-To
Time display with the current time displayed. Use the Up or Down
arrows to set the time period that you want to hold the desired
temperature. The Up and Down arrows changes the time in 30
minute increments. The maximum hold time is 24 hours.
When you have selected the desired time press the key below the
Enter key label in the smart-key label at the bottom right of the
display to select this new mode. If you decide to cancel the
operation then press the key below the Cancel key label in the
smart-key label at the bottom left of the display.
Alternately, if you let the programs screen time out with Hold for
Time highlighted, by the highlight bar, the hold mode is selected
and the screen updates to the Set Hold-To Time display.
On the main screen Hold to with the desired hold to time is
displayed above the current temperature information.