Configuring qic tape and cd-rom, Guide – Unisys NX5820 User Manual
Page 105
Configuring QIC Tape and CD-ROM
7017 6300–005
5–17
Configuring QIC Tape and CD-ROM
Standard system models include both quarter-inch cartridge (QIC) tape and CD-ROM.
Refer to the Unisys e-@ction ClearPath Enterprise Servers A Series and NX
Systems I/O Configuration Guide
(7008 6087)
for guidelines on configuring these
devices.
Information Contained in the NX Systems I/O
Configuration Guide
Use the Unisys e-@ction ClearPath Enterprise Servers A Series and NX Systems
I/O Configuration Guide
(7008 6087)
for information relative to the I/O subsystem
from the channel interface outward. The topics covered in that guide are outlined below.
•
I/O Cabinets and bases:
−
Independent I/O (IIO) cabinets
−
I/O bases
Note:
I/O Cabinets and racks available with the NX Systems are covered in
Section 4 of this guide.
•
Standard I/O subsystems supported on the system:
−
Small computer system interface (SCSI) subsystem channels SCSI-2W and
SCSI-2N
−
Direct-attach subsystem/channels
ο
Fiber and copper distributed data interface (FDDI/CDDI) local area networks
(LANs)
ο
802.3 LANs
ο
Message level interface (MLI) channel
ο
Asynchronous transfer mode (ATM) network
•
Migration I/O subsystems supported on the system:
−
MLI-based SCSI
−
Data communications subsystems using data link processors (DLPs)
ο
Network support processor (NSP)
ο
Line support processor (LSP)
ο
EDC DLP
ο
Integrated communications processor (ICP)
ο
CP2000 communications processor
−
Communications processor local area network (CPLAN)