Univex LD190SS1 - Manual (Page 23)

21
EN
INTRODUCTION
PREPARATION
WATCHING TV
OPTIONAL SETTING
OPERATING DVD
DVD SETTING
TROUBLESHOOTING
INFORMATION
English Español Français
 Channel List
The channels selected here can be skipped when selecting the channels
using [CH K / L].
Those channels can still be selected with [the Number buttons].
1
Press [SETUP] to display the main menu.
2
Use [Cursor K / L] to select “CHANNEL”, then press
[ENTER].
3
Use [Cursor
K / L] to select “Channel List”, then press
[ENTER].
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
4
Use [Cursor
K / L] to select the channel you want to
remove, then press [ENTER].
Channel List Channel List
DTV 8 DTV 8
9 9
DTV 48 DTV 48
58 58
DTV 6 DTV 6
27
DTV 67
Ch Select Watch/Skip Back BACK
ENTER
Highlight channels for Ch
Up/Down key selection.
• The channel display for the removed channel
darkens. You will not be able to select the channel
again using [CH
K / L].
• To reactivate a removed channel, use [Cursor
K / L] and
press [ENTER]. The registered channels are highlighted.
• When you remove a main channel, its subchannels
are removed as well.
Note:
• The channel with the “DTV” indicated on the display is
ATSC. Otherwise the channel is NTSC.
5
Press [SETUP] to exit.
 Manual Register
This function lets you add the channels that were not added by
the autoscan due to the receptible condition at the initial setting.
1
Press [SETUP] to display the main menu.
2
Use [Cursor
K / L] to select “CHANNEL”, then press
[ENTER].
3
Use [Cursor
K / L] to select “Manual Register”, then
press [ENTER].
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
4
Use [the Number buttons] to enter the number of the
channel you want to add, then press [ENTER].
Manual Register Manual Register
Register
Ch Change
11
Back BACK
For analog channels, select a
channel to register using number
keys.
For digital channels, you must
perform Autoscan function.
5
Press [SETUP] to exit.
Note:
• If setup completes successfully,
“Added to the channel list” is displayed.
• If external input is used, it is not possible to register the
channel and “Unavailable” will be displayed on the TV
screen.
• By using [CH
K/ L], you can select the memorized
channels only.