Uniden TL27WRA-B - Manual (Page 15)

Preparing and Using the Remote Control
How to insert the batteries
• When operating the remote control, point its top edge at the
remote control IR receiver on the TV. Operate the remote control
within seven meters, 30° on the left and right and 15° above and
below the receiver.
• If the TV cannot be operated by remote control operation (but by
the buttons on the TV), a probable cause is that the batteries in
the remote control have reached the end of their service life.
• Replace with new batteries.
• Do not leave or attach the remote control in a location subject to direct sunlight.
• Heat may deform the remote control and cause it to malfunction.
• The remote control becomes more difficult to operate if direct sunlight or bright overhead lighting falls
on the remote control IR receiver on the TV. Either re-orient the lighting or TV, or bring the remote
control closer to the remote control IR receiver.
• Do not subject the remote control to strong impact. Also, do not allow it to get wet or leave it in very
hot locations.
Close the battery compartment cover.
Rest the cover along the back with the clip
aligned and push/slide the cover until you
hear it click into place.
Insert the batteries.
Insert two AAA batteries by matching the +
and - terminals on the batteries to the dia-
gram inside the battery compartment.
(Make sure that the poles are facing the cor-
rect direction.)
Open the battery compartment cover.
Remove the cover by pushing down where
the cover edge is marked and slide the cover
backwards.
How to use the remote control
Left/right 30°
Up/down 15°
Remote Control signal range
7 metres
SET
UP
15
1 2
3