Uniden TL27WRA-B - Manual (Page 9)

Notes on Use (continued)
Recommendations (continued)
Avoid direct sunlight or steam.
• Do not install this product in direct sunlight
or near heating equipment. Doing so may
adversely influence the chassis or compo-
nents.
• Leaving this product in locations such as
vehicles with closed windows that become
excessively hot may deform the chassis or
cause this product to malfunction.
Avoid using this product in rooms and
locations subject to sudden changes in
temperature.
•
Doing so may impair the definition of the
display.
Use in low-temperature rooms and
locations
• If this product is installed in a cold room or
location, smears may appear in the picture
or the picture may be delayed on screen.
This is not a malfunction. These phenomena
improve as room temperature is restored.
• Do not install this product in locations where
the temperature will drop. Doing so may de-
form the chassis or cause the LCD screen
to malfunction. Recommended operating
temperature: 0 to 40C
Condensation
• If this product is suddenly transfered from a
cold to a warm location or if the room tem-
perature changes suddenly (e.g. by turning
on the heating on a winter’s morning), con-
densation (water droplets) may form on its
surface or inside. Continued use in this condi-
tion may cause malfunction. If condensation
occurs, wait a while for the condensation to
disappear before plugging the power cord
into the power outlet.
Caution
INTRODUCTION
9