Connecting other equipment (cont’d) – Uniden TL27WRA-B User Manual
Page 22
About connector covers
• Removal
27 and 32 inch models:
Press down on the lip at the top and pull
towards you to remove it.
• Installation
27 and 32 inch models:
Insert the two protrusions at the
bottom into the holes on the body,
and press in the top until it is locked
in place. Next, press in the center
section to lock the protrusions on the
left and right.
* Take care not to pinch the cords.
Arranging the cables
Pass the cable through the notch in the cover.
(The cover can also be removed.)
22
SET
UP
Press down
here.
Pull this way.
cover tabs
37 and 42 inch models:
Press on the two tabs on the right and pull
towards you to remove it.
37 and 42 inch models:
Align the three tabs on the left into the
holes on the body and press the into the
left side until it is locked in place. Next,
press the right section to lock in the right
side tabs.
cover tabs
Connecting Other Equipment (cont’d)