Uniden BR330T - Manual (Page 54)

54
Turning Power Save On or Off
Settings
Set Battery Save
• On The scanner goes into low-power mode when you
monitor a conventional channel that has no activity.
• Off Power save is off.
Priority Scan
Set Priority
Or, while holding on any channel, press + 1/pri
to select one of these priority modes:
• Off Normal scanning
• On While scanning a conventional system, the
scanner interrupts every 2 seconds and checks
the priority channels in each unlocked conventional
system. Priority channels in lower priority key
numbered systems (starting from 1) have highest
priority. PRI appears when you select this mode.
• Plus On The scanner only scans priority
channels in unlocked conventional systems.
PRI flashes when you select this mode.
Other Setting
s
Using the Backlight
Settings
Set Backlight
• 10 sec The backlight stays on for 10 seconds
after you press .
• 30 sec The backlight stays on for 30 seconds
after you press .
• Squelch The backlight turns on when the
squelch opens then stays on for 5 seconds.
• Keypress The backlight turns on when any key
is pressed then stays on for 10 seconds.
• Infinite The backlight turns on when you
press then stays on until you press again.
Menu
Menu
Func
Menu