Uniden BR330T - Manual (Page 55)

55
Other Settings
Pressing any key while the backlight is on extends the
backlight period. Pressing
while the backlight is on
turns off the backlight.
Setting the Audio AGC
Settings Set Audio AGC
This setting helps balance the audio level you hear as
you listen to different radio sources so you can hear
them at a similar volume. Use this setting if you listen
to an audio source that has natural changes in audio
level for which you want to compensate.
• On Press the scroll control to select. Audio AGC is
turned on.
• Off Press the scroll control to select. Audio AGC
is turned off.
Selecting the Bar Antenna
Settings Set Bar Antenna
This setting lets you switch between the internal bar
antenna and the antenna connected to the SMA connector.
Note: The bar antenna receives signals between 0.1
and 1.7 MHz. It cannot receive signals out of this
range even if you select it.
• On Press the scroll control to select.
The bar antenna is selected.
• Off Press the scroll control to select.
The antenna attached to the SMA connector is
selected.
Tuning The Bar Antenna
Follow the steps under “Selecting the Bar Antenna” for
best reception of AM radio signals.
1. Make sure to select the Bar Antenna
2. Tune to a frequency between 0.1 and 1.7 MHz.
3. Hold down and tap the scroll control twice.
Menu
Menu
Func