Uniden BC250D - Manual (Page 23)

5:TONE DATA
The default mode is 2:OFF. This means that
you will receive all transmissions on any
frequencies that are active within your search
range(s). By selecting CTCSS or DCS you
can set the radio to receive only a particular
subaudible tone to be received during your
search. You can also lockout a particular
CTCSS or DCS tone. You may wish to do this
if you want to search a range but not hear
transmissions on any frequency that has a
particular subaudible tone.
Note: Through the System Menu you can set
the radio to operate in Tone Search
mode during Search as well. In this
mode, the radio will automatically
determine the active subaudible tone
on any frequency received during the
search.
6:AUTO STORE
You can automatically store active
frequencies found during a search into the
memory. You can select which bank you want
to program the found frequencies. The audio
will be muted during Auto Store.
2:SCAN OPTION
1:CONVENTIONAL
Choose the channel number. The following options
are available for the selected channel only.
Repeat using a different channel number, if
necessary.
1:FREQUENCY
Allows you to edit or enter a frequency in
each channel you select.
Also you can set an alphanumeric text tag for
each programmed frequency.
2:DELAY
The delay for all programmed channels is
2 seconds. At the end of any transmission
the scanner will remain on the frequency for
2 seconds before resuming scanning.
This will allow you to catch most replies.
3:TONE DATA
You can set a CTCSS (analog) or DCS
(digital) subaudible tone for a frequency.
19
BC250D 11/6/2 11:36 AM Page 19