Uniden BC250D - Manual (Page 89)

85
Key Beep Option
To choose key beep sound 1:ON or 2:OFF:
1. Press MENU/BACK.
2. Select 3:SYSTEM OPTION / 3:KEY BEEP by
rotating the VFO and pressing E.
3. Select 1:ON or 2:OFF by rotating the VFO and pressing
E.
Screen Mask
The trunk, frequency, receiving mode, and signal meter
indications on the display are masked when this feature is
activated (except while in Search mode). This feature reduces
the amount of displayed information.
Note: While Screen Mask is ON, Enter Lock is active.
1. Press MENU/BACK.
2. Select 3:SYSTEM OPTION / 2:SCREEN MASK by
rotating the VFO and pressing E.
3. Select 1:ON or 2:OFF by rotating the VFO and pressing
E.
Reverse Mode
This key will allow you to observe the reverse frequency of
the repeater. While pressing REVERSE, the standard pair
frequency will be displayed. For a list of the standard pair
frequencies, refer to the table "Reverse List" in the Appendix.
If the frequency that you have chosen does not have an offset
frequency, the display will indicate ERROR and NO
REVERSE. This feature does not work in the Weather
Search mode.
Channel Step Selection
You can set channel steps, 5 kHz - 100 kHz or Auto, in
Conventional mode or Chain Search mode. The default
receive mode should be the proper mode setting in almost
all cases. You may wish to set some VHF channels for NFM
mode, depending on any adjacent channel interference
problems. WFM is typically only used for broadcast
frequencies such as TV audio or FM radio.
See STEPS in "Menu Description" for details.
Mute On/Off
To manually turn ON the Mute function, press and hold MUTE
until MUTE ON is displayed.
BC250D 11/6/2 11:37 AM Page 85