Uniden BC250D - Manual (Page 39)

35
Changing the Priority Channel
You cannot eliminate the Priority Channel, but you can
change it to any one of the 100 available channels in each
bank.
1. Press HOLD/MAN.
2. Select a new Priority Channel:
a. Enter the channel number using
the keypad.
b. Then press HOLD/MAN again.
3. Press and hold PRI for 2 seconds to
designate this channel as your new
Priority Channel.
Two beeps indicates that the Priority
Channel has been changed. The P
icon appears on the display.
Note: • Priority in Trunking mode works just the same,
except you set them for talkgroup IDs, instead of
setting priorities for channels. The scanner only
checks priority talkgroups between transmission,
in 4 second intervals.
• Priority Scan is disabled while M, E or L (Trunking
type) icons are illuminated (a beep will sound if you
try to scan). To make it possible, turn OFF each
function then press PRI to select PRIORITY ON.
Priority Channel Plus Scan
You can scan only the Priority Channels (except for the lock
out channels) in the banks you selected. To activate Priority
Channel Plus
(Only in Scan mode):
1. Press PRI to select PRIORITY PLUS.
2. Press PRI to select PRIORITY ON or PRIORITY
OFF on the display to deactivate Priority Channel Plus
Scan.
Note: Priority or Priorty Plus Scan are disabled while Search
mode is selected.
HOLD/
MAN
SCAN
CH/
FRQ
MENU/BACK
L/O
.
SELECT REVERSE
TRUNK
E
RSM
SEARCH SERVICE
C 001
512.0000 NFM
UHF TV 1
UNIDEN Group A
BC250D 11/6/2 11:36 AM Page 35