USRobotics NETServer/8 - Manual (Page 265)

RADIUS F-5
Framed-Address
This is the user’s IP address for the duration of the connection.
If this line is omitted, NETServers which have a pool of assigned
addresses set up will use assigned addressing. NETServers
without such a pool will attempt to negotiate the address.
Framed-Address=192.77.203.76
Framed-Compression
Default is Van-Jacobson-TCP-IP. This field specifies whether or
not Van-Jacobson header compression is used. Examples:
Framed-Compression=Van-Jacobson-TCP-IP
Framed-Compression=None
Framed-Filter-Id
The two packet filters specified here control which packets will
be allowed to pass from the NETServer to the user and vice
versa. The command looks something like the following:
Framed-Filter-Id=<filter name>
The NETServer will take the filter name given here and add .in
and .out extensions to get the names of the input and output
filter that will be used. For example, if you typed the following
line,
Framed-Filter-Id=xyz
the NETServer would look for two filters: xyz.in and xyz.out.
You must create a filter for each of these names (See Chapter 8).
If you do not create a filter for one of these names, the user will
have no filter for that function.
Framed-MTU
The Maximum Transmission Unit (MTU) specifies the largest
packet that will be sent from the NETServer to this user. Larger
packets will be discarded for IPX connections. IP packets larger
than this value will be fragmented prior to transmission. PPP
connections are set between 100 and 1500 (default is 1500), and
SLIP connections are set between 100 and 1006 (default is 1006).
Example:
Framed-MTU=1500