USRobotics NETServer/8 - Manual (Page 68)

5-10 Network Dial In Access
Routing
Set the level of RIP messaging that the two devices will ex-
change during the connection. Use the following command:
set user <name> routing <option>
<option> can be any one of the following:
broadcast Send dynamic routing information to the dial in user
(but do not listen)
listen Listen for dynamic routes received from the dial in
user (but do not broadcast)
on Do both of the above
off Do not send dynamic routing information. Ignore
dynamic routes received
Compression
If using SLIP, enable Van Jacobson IP header compression only if
both networks use CSLIP (compressed SLIP).
If compression is enabled for a PPP connection, the NETServer
will attempt to negotiate for compression, but will not use it if
the remote site does not support compression.
set user <name> compression < on | off>
Step 4 - Save your changes
Use the following command:
save user