VTech gz2334 - Manual (Page 6)

4 5
Setup
Check for Dial Tone
After the battery is charged, connect the modular telephone cord between a live phone
jack and the jack located on the bottom of the base unit. Pick up the handset and press
ON. You should hear a dial tone.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT! FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your base unit.
2. Install your base unit and extension handsets away
from electronic equipment, such as personal
computers, television sets and microwave ovens.
3. In locations where there are multiple cordless
telephones, separate base unit as much as pos-
sible.
4. Install your telephone equipment away from heat
sources and sunlight.
5. Avoid excessive moisture, dust or extreme cold.
Remove Re-attach
Removable Handset and Base Plates
Your gz 2334 comes with additional handset
and base plates of various colors. You can
interchange these plates to suit your mood or
room decor.
Handset Plate
Carefully remove the handset face and/or
back plate by pressing the button on the top of
the handset, then pulling the plate off. Attach
the new face and/or back plate by snapping
the lower portion, then the upper portion into
position.
Base Plate
Carefully remove the base plate by pressing the button on the right side of the base unit,
then pulling the plate off. Align the new base plate, making sure the antenna passes through
the appropriate slot. Secure the plate by snapping it into position.
Remove Re-attach
Getting Star
ted