VTech DECT DS6121-2 - Manual (Page 41)

www.vtechphones.com
B
as
ic
o
pe
ra
tio
n
Answering system
A
ns
w
er
in
g s
ys
te
m
Set telephone base ringer
This feature allows you to select the telephone base ringer volume level. You can
choose from HI (high), OF (off) or LO (low).
Press SETUP when the telephone is not in use until the system announces
the telephone base ringer setting.
Press
/SKIP or /REPEAT until the system announces the desired telephone
base ringer volume level, then press SETUP to save the setting and go to the
next setting, or press / PLAY/STOP to save and exit setup mode.
Set remote access code
A two-digit security code is required to access the answering system remotely
from any touch tone telephone. The preset code is 19. You can set the code
from 10 to 99.
To set the remote access code:
Press SETUP when the telephone is not in use until the system announces
the remote access code setting.
Press / SKIP or / REPEAT to change the remote access code by one, or
press and hold / SKIP or / REPEAT to change it by increments of ten. Press
SETUP to save the setting and go to the next setting, or press /PLAY/STOP
to save and exit setup mode.
1.
2.
1.
2.
The handset
ringer volume is
set separately.
See page 8 for
details.
•
37