Volvo 2007 S80 - Manual (Page 201)

06 Maintenance and specifications
200
Wheels and tyres
06
Variant 1
Inflating tyres
1. Ensure that the orange switch is in
position 0 and take out the lead and air
hose from the side compartment .
2. Unscrew the wheel’s dust cap and
screw in the air hose valve connection
to the bottom of the thread on the tyre’s
air valve.
3. Connect the lead to one of the car’s
12 V sockets.
4. Start the engine.The car must be in a
well-ventilated place.
5. Start the compressor by flicking the
switch to position I.
6. Pump up the tyre to the pressure speci-
fied on the tyre pressure label.
7. Switch off the compressor, the
switch should be in position 0. De-
tach the air hose and unplug the lead.
Refit the dust cap.
8. Put the lead and air hose into the
side compartment .
9. Put the puncture repair kit back under
the floor in the cargo area.
The compressor must not run for more than
10 minutes. Let it cool afterwards as there is
a risk of overheating.
Objects with a volume up to 50 litres can be
inflated with the compressor.
Sealing punctured tyres
1. Remove the decal regarding the high-
est permitted speed from the emergency
puncture repair kit and stick it on the
steering wheel where it can be clearly
seen by the driver.
2. Ensure that the orange switch is in
position 0 and take out the lead and
3
2
7700609s
5
4 8
6000034s
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suffi-
cient ventilation.
3
2
7700609s
1 6
7700610s