Volvo 2007 S80 - Manual (Page 205)

06 Maintenance and specifications
204
Wheels and tyres
06
Variant 2
Overview
Decal, maximum permitted speed
Switch
Cable
Bottle holder (orange cap)
Protective cap
Pressure reducing valve
Air hose
Sealing fluid bottle
Pressure gauge
Gloves
Inflating the tyres
The car’s original tyres can be inflated by the
compressor.
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel’s dust cap and
screw in the air hose valve connection
to the bottom of the thread on the tyre’s
air valve.
3. Connect the cable to one of the car’s
12 V sockets and start the car.
4. Start the compressor by flicking the
switch to position I.
5. Inflate the tyre to the pressure specified
on the tyre pressure decal. (Release air
using the pressure reducing valve if the
tyre pressure is too high.)
6. Switch off the compressor. Detach the
air hose and cable.
7. Refit the dust cap.
10
G014337
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suffi-
cient ventilation.
IMPORTANT
Risk of overheating. The compressor must
not run for more than 10 minutes.