Vanguard Managed Solutions 650 - Manual (Page 61)

Installing and Coldloading 650 Series Software 3-23
Selecting a Predesigned Configuration
Saving and Restoring Configurations Using TFTP
Introduction TFTP can also be used to transfer CMEMs from a server to the 650 Series node.
Before You Begin Ensure that the configuration you wish to download resides on the TFTP server, and
obtain the filename. Also obtain the IP address of the server. PING the TFTP server
to verify that you have IP connectivity between the TFTP server and the 650 node.
Saving
Configurations
Using TFTP This table describes how to save a configuration using TFTP.
Step Action Result
1 Access the control port, and from
the Main menu, select
Configuration Save/Restore. The Configuration Save/Restore
menu appears.
2 Select TFTP Save Configuration
from the Configuration Save/
Restore menu. The Enter file name: prompt
appears.
3 Enter the name of the
configuration file to which you
wish to save. The default file name
is NODENAME.MEM. The Enter IP address: prompt
appears.
4 Enter the IP address of the TFTP
server. The Ready to initiate TFTP
transfer?: prompt appears.
5 Enter Y to start the transfer. The transfer begins. If it is
successful, the message
Operation
Successful. appears.
If the transfer fails, the message
Local Transfer Failure. appears. You
can then retry the operation.