Vanguard Managed Solutions 650 - Manual (Page 7)

iii
About This Manual
Overview
Introduction This manual describes features, hardware, specifications, and applications for the
Vanguard 650 Series of products. This revision of the Manual is specific to the
manual 651/653 and 652/654 models of the product.
For information on operating system software and configuration, see the Vanguard
Documentation Kit.
Audience This manual is intended for operators of Vanguard 650 Series products.
Software Revision
Level The 650 Series runs Release 5.0 and greater of the Network Access Series operating
software. For software releases higher than 5.0, refer to the Software Release Notice
for the software release to determine if it is applicable to the 650 Series.
Chapter
Descriptions The following table describes the contents of this manual.
This section... Describes...
Chapter 1 the 650 Series of products, the shipment contents,
hardware installation and cabling, and shows the
power-up sequence for the 650 Series.
Chapter 2 accessing and navigating the control port of the 650
Series to verify or change parameters, to check
statistics, or to boot the node.
Chapter 3 updating your operating software, and saving or
restoring a supplied configuration file.
Appendix A the physical and environmental specifications and
power requirements for the 650 Series.
Appendix B software license and regulatory information.