VistaQuest VQ 350 - Manual (Page 16)

-12-
resolution is that you may store more images (four times more) than VGA resolution images.
If you would like to use the QVGA resolution, turn on the camera. Press the Mode button until
“ ” appears on the LCD display and “ Hi ” starts flashing on and off. Press the Shutter button
to change “ Hi ” to “ Lo ”---which is the QVGA mode.
If you would like to change resolution from QVGA to VGA, press the Mode button until “ ”
appears on the LCD display and “LO” begins flashing on and off. Press the Shutter button to
change “ LO ” to “ Hi .”----which is the VGA mode.
3.11 High/Low Image Compression
Press the Mode button until HD/LD appears on the LCD display. Press the Shutter button to set
the picture to “ HD ” (highest image quality, using the least compression) or “ LD ”(lower image
quality, using more compression). Higher quality images captured in the HD Mode will use more
of your camera’s available memory (storage space). The LD Mode allows you to store more
images, but of a lesser quality.
3.12 Light Frequency
When capturing images or movie clips under indoor lighting, the image quality will be best if you set
the camera to match the frequency of the room-lighting. In general, 60 Hz frequency is used in
US and Asia, whereas 50Hz is most common in UK, Japan, and Europe. To change the
frequency, turn on the camera. Press the
Mode button until “ 50 ” or “ 60 ” appears on the LCD
display. Press the Shutter button to choose the setting you desire.
3.13 Using the Flash – Automatic (SA) or On (SF)
Press the Mode button until SA/SF appears on the LCD display. Press the Shutter button to set
the flash to automatic flash (Strobe Automatic) or forced flash (Strobe Forced). In automatic mode,
the camera will determine if the flash is needed, or not. In forced mode (also known as “fill” flash)
the flash will always fire, regardless of lighting conditions.