VBrick Systems MPEG-1 - Manual (Page 12)

6 EtherneTV Media Distribution System
b. Select Network again.
c. Select Domain NameServer IP Addresses and enter the Nameserver IP addresses. (If
there is more than one, separate the entries with the pipe character (|), for example
172.16.1.11|172.16.1.10
.)
15. When done, use the up arrow key to reach <. . . > and select using the Enter key on each
screen. Answer Yes when prompted to apply changes and Exit to return to the user
prompt level. Wait until the changes are applied and the interface returns; otherwise the
changes may be lost.
16. Reboot by powering the STB on and off using Power push button on front of unit.
PAL Configuration
The
setres
command than can be executed from the Linux shell. This command lets PAL
users change the screen resolution. Although this command can be executed from the
Command Prompt or from Telnet, it is designed to be used from the serial port since a PAL
user without an NTSC or VGA monitor has no other choice if the STB IP address is
unknown. The syntax of the
setres
command is:
setres pal <username> <password>
setres ntsc <username> <password>
Model Numbers
The STB model number is shown on a label attached to the bottom of the unit. The
functionality in the following table is cumulative. The model at the bottom of the list inherits
all features and functions from the previous model. Any firmware is compatible with any
model; all models support MPEG-1, MPEG-2, and MPEG-4 streams.
Model Number Enhancements
8000-0044-0000 Base model.
8000-0044-0001 Improved MPEG-1 quality.
8000-0044-0002 Serial port added.
8000-0044-0003 Closed caption support added.