VBrick Systems MPEG-1 - Manual (Page 18)

12 EtherneTV Media Distribution System
C:\> ftp 172.22.117.70
User (172.22.117.70:(none)): root
331 Password required for root.
Password: admin
230 User root logged in
ftp> bin
200 Type set to I.
ftp> cd wfs/mpg
250 CWD command successful.
ftp> put vbs1d1.sdp
200 PORT command successful.
150 Opening BINARY mode data connection for vbs1d1.sdp
226 Transfer complete.
ftp: 739 bytes sent in 0.12 Seconds
ftp> bye
Local UI Location
When the Start Mode is configured for Local, the STB will display static listings and previews
of multiple channels on the network. These listing are configured in an xml file. The xml file
must be modified for each network installation so that IP addresses, port numbers, encoder
types and program listings correspond to actual network settings. This file is edited for local
mode installations only and does not apply when operating in
MCS or Local-Full Screen
mode. For detailed examples of how to edit the xml file, go to XML Configuration Examples
on page 23.
Home Page Location/Home Page Enable
Main Volume/Line 1 Volume
In MCS mode, when the volume has been manually turned down using the remote (and the
configured audio level is significantly higher), there will be a brief burst of higher volume
when switching views between preview and full screen. Reduce the configured audio level to
avoid abrupt changes in volume.
Local UI Location When the start mode is configured for Local, the STB will allow static
listings and previews of multiple channels on the network. You can
use this setting to create a custom user interface.
Home Page
Location/Enable This parameter determines the location of the home page that is
displayed when the WWW button is pressed on the IR remote control.
When this option is disabled, the Home page will not be loaded when
the WWW button is selected.
Main and Line 1
Volume These parameters determine the initial volume level the STB will
provide to the TV or monitor. Set both to same value. The volume can
be changed using the IR remote control but will revert to the
configured values at start-up.