VTech i6790 - Manual (Page 30)

www.vtechphones.com 27
Answering system operation
Answering system setup
Activate the answering system
The answering system must be turned on to answer and record messages.
If the answering system is turned off, the telephone base ANS ON/OFF light
will be off.
• To turn the answering system on or off, press
ANS ON/OFF.
• Press and hold
/SKIP or
/ REPEAT
during setting the
minutes or year by
increments of ten.
• Incoming caller ID
data sets the time
and date. You’ll
need to set the
year so the day
of the week can
be determined
from the caller ID
information. The
time will be set
automatically only
if you subscribe to
caller ID service
provided by your
local telephone
company.
• Setting this clock
will not affect the
handset clock (see
page 12), they are
individual settings.
Set the clock
Before playing each message, the answering system announces the day
and time the message was received. You should set the day and time before
using the answering system so messages are dated correctly. If the clock
has not been set before you receive messages on your answering system,
it will announce “Time and day not set.” To set the clock:
• Press CLOCK, the system will announce the current clock setting. The
system will then announce “To set the clock, press CLOCK.”
• Press CLOCK again and the system will announce the year.
• Press /SKIP or /REPEAT until the system announces the correct year,
then press CLOCK. The system will announce the hour.
• Press /SKIP or / REPEAT, until the system announces the correct
hour, then press CLOCK. The system will announce the minute.
• Press /SKIP or / REPEAT until the system announces the correct
minutes, then press CLOCK. The system will announce the day.
• Press /SKIP or / REPEAT until the system announces the correct
day, then press CLOCK. The system will announce the new clock setting
and return to idle mode.