VTech i6790 - Manual (Page 5)

www.vtechphones.com 2
In
sta
lla
tio
n
B
as
ic
o
pe
ra
tio
n
Installation
Telephone base installation
It is recommended to install the telephone base away from any electronic equipment and appliances
such as personal computers, computer routers, television sets, microwave ovens, and refrigerators.
Avoid excessive heat, cold, dust or moisture. When a location is selected, install the telephone base
and the charger as shown below.
• Plug the connector into the power jack at the bottom of the telephone base and chargers. Route cords
through slots and plug the power adapter into an electrical outlet not controlled by a wall switch.
• Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone
base. Route the telephone line cord through slot, then plug the other end of the cord into the
modular wall telephone outlet.
Your telephone base comes with the bracket installed for desktop use. If you prefer to mount your
telephone on the wall, plug in the telephone line cord and the power adapter to the telephone base as
instructed above before changing it to a wall mount position (see page 7 for bracket installation).
• Use only the AC
power adapter
supplied with this
telephone.
• This power unit
is intended to be
correctly oriented
in a vertical
or floor mount
position. The
prongs are not
designed to hold
the plug in place
if it is plugged
into a ceiling or
an under-the-
table/cabinet
outlet.
Plug the telephone
line cord into a
telephone jack.
Plug power adapter
into an electrical
outlet not controlled
by a wall switch.