Viper 5902 - Manual (Page 40)

Feature Details
37 © 2009 Directed Electronics. All rights reserved.
Note As a precaution, if programmed for Passive Arming or Auto
re-arming the system should be placed into Valet Mode until
a remote is available .
Trigger Zone Fault Report
When armed by remote command the system runs a status check
of the alarm trigger zones. Faulty zones (usually caused by dome
light delay or open trunk) are bypassed and reported via the control
center LED and remote, while all other trigger zones remain active
and are monitored to protect the vehicle. Should a faulty zone self
correct (dome light turns off) it becomes active and is then monitored
normally.
The siren chirps once again a few seconds following the arming chirps
as an audible alert, the control center LED flashes in groups to indicate
the zone number. The remote emits a fault tone, displays a screen for
each faulty zone, and then updates the Sensor status icon in the Status
screen. Press any button within 20 seconds of the fault tone to review
the report without performing a command.
Alarm Trigger Report
The most recent alarm triggers (if any) are reported when the
alarm is disarmed via the remote control, siren chirps, parking light
and control center LED flashes. The siren chirps 4 times (or 5 times if
NPC On*), the lights flash 3 times, and the control center LED flashes
in groups to indicate the last two zones that were triggered (see Table
of Zones). The remote control Disarm output is replaced by screens
and beeps that identify the two most recent triggers.
* See Nuisance Prevention (NPC) following this for more details.