Vector Start-It VEC016 - Manual (Page 3)

3
IMPORTANT:
Although this unit is delivered in a partially-charged state - you must fully charge it with
the supplied 110/120 Volt AC charger for a full 24 hours before using it for the first time.
You can not overcharge the unit using the AC charger method.
CAUTIONS:
Caution statements advise against certain conditions and practices that may result in
damage to vehicles, appliances and/or The START-IT Compact Jump-start System.
1) Use only the supplied cords/adapters for recharging this unit. Do not recharge for more
than 3-4 hours maximum using 12 Volt DC method. Recharge unit after each use.
2) All On/Off switches should be in the OFF position when the unit is charging or not in use.
Make sure all switches are in the OFF position before connection to a power source or
load.
3) Never insert anything other than the supplied power/recharging cords or recommended
appliance power/recharging cords into the 12 Volt DC charging/power socket on this
unit. Do not use any accessory that is not recommended or provided by the manufacturer.
4) Do not use this unit to operate appliances that draw more than 15 amps.
5) This system is designed to be used only on vehicles with 12 Volt DC battery systems. Do not
connect to a 6 Volt or 24 Volt battery system.
6) This system is not designed to be used as a replacement for a vehicular battery. Do not
attempt to operate a vehicle that does not have a battery installed.
7) Vehicles that have on-board computerized systems may be damaged if vehicle battery is
jump-started. Before jump-starting, read the vehicle’s owner’s manual to confirm that
external-starting assistance is advised.
8) Excessive engine cranking can damage a vehicle’s starter motor. If the engine fails to start
after the recommended number of attempts. Discontinue jumpstart procedures and look
for other problems that may need to be corrected.
9) Although this unit contains a non-spillable battery, it is recommended that unit be kept
upright during storage, use and recharging. To avoid possible damage that may shorten
the unit’s working life, protect it from direct sunlight, direct heat and/or moisture.
10) Check unit periodically for wear and tear. Replace worn or defective parts immediately
contact Vector customer service department at (954) 584-4446 or toll-free
(954) 584-5504.
11) Do not attempt to jump-start a frozen battery.
12) Never submerge this unit in water.
13) All wires, cables and cords must be positioned so that they can not be tripped over or
damaged by moving parts, by pinching or abraiding.