Vector Start-It VEC016 - Manual (Page 7)

7
READ INSTRUCTION MANUAL AND PRODUCT LABELING CAREFULLY, BEFORE USING THIS
PRODUCT. FOLLOW RECOMMENDED WARNINGS, CAUTIONS, AND SAFETY PROCEDURES,
AND MANUFACTURER’S GUIDELINES FOR YOUR VEHICLE BATTERY.
IMPORTANT
This unit is delivered in a partially charged state - you must fully charge it before using it for the
first time. Initial AC Charge should be for 24 hours.
Refer to Sections 4.1 and 4.2 for use of AC Recharge Adapter and DC/DC Charging Adapter.
2. USE AS A JUMP-START SYSTEM
2.1 JUMPSTART WARNINGS
1. There is risk of explosive gas being released when batteries are improperly charged or
discharged. Failure to follow instructions may Cause property damage, explosion hazard,
and/or personal injury.
2. Do not smoke while jump starting
3. Only attempt to jumpstart a vehicle or boat in a well ventilated area.
4. This power system is to be used ONLY on vehicles or boats with 12-volt DC battery systems.
5. Do not attempt to jumpstart a frozen battery.
6. Do not wear vinyl clothing when jumpstarting a vehicle — friction can cause dangerous
static electricity sparks.
7. Remove all metal jewelry - this can cause short circuits. Always use protective eyewear
when jump-starting: contact with battery acid may cause blindness and/or severe burns.
8. Never touch red and black clamps together - this can cause dangerous sparks, power
arcing, and/or explosion.
9. Do not attempt to jumpstart a frozen battery
10.After use as jump starter, turn OFF Power Safety Switch. Keep out of reach of children.
11.Vehicles that have on-board computerized systems may be damaged if vehicle battery is
jump-started. Before jump-starting this type of vehicle, read the vehicle’s owner’s manual to
confirm that external-starting assistance is advised.
12.Always start jump-starting with Power Safety Switch turned OFF - this allows the polarity
alarm to sound if reverse (incorrect) polarity connection is made.
WARNING: Reverse Polarity Alarm Sounds, Reverse the cable clamp connections.
13.Excessive engine cranking can damage the vehicle ‘s starter motor. If the engine fails to start
after the recommended number of attempts, discontinue jump-start procedure and look for
other problems that may need to be corrected.
14.If vehicle to be started has a Positive Grounded System (positive battery terminal is
connected to chassis): Replace steps 9 and 10 of the jump-start procedure (below) with the
following steps A and B, and then proceed to step 11.
A. Connect negative (-) black clamp to vehicle battery ‘s negative terminal.
B. Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal vehicle
component or body part. DO NOT clamp directly to positive battery terminal or moving part.
15.Replace worn or defective parts immediately - contact Vector Customer Service
Department at (954)584-4446 or toll free at 866-584-5044.
2.2 FIRST AID:
• SKIN: if battery acid comes in contact with skin, rinse Immediately with water, then wash
thoroughly with soap and water. If Redness, pain, or irritation occurs, seek immediate
medical attention.
• EYES: if battery acid comes in contact with eyes, flush eyes Immediately-for minimum of 15
minutes-seek immediate medical attention.