Verilux VH04WW1 User Manual
Page 24
24
7. Care and Maintenance — continued
7.2 Cleaning and Replacing Filters
For best performance, clean filters after each use. Replace filters
periodically depending on frequency of use and the amount of dirt
picked up with each use.
Note: If the Power Head Mode Indicator light begins to rapidly blink
RED, the airflow may be blocked. The Low Airflow Indicator (A) may also
be illuminated. Clean all filters as directed below.
How to Clean
Before cleaning or replacing any filters, disconnect Power Cord from
electrical outlet.
7.3 HEPA-12 Pre-Filter
The HEPA-12 Pre-Filter (B) is located outside dirt cup (C).
1. Remove the Dirt Cup (C) by lifting up on the Release Latch (D).
2. The HEPA-12 Pre-Filter (B) can be removed by pressing the
Release Tab (E) and rotating away from the Dirt Cup (C).
3. Gently tap the filter on the inside of a garbage receptacle to remove
excess dust and dirt.
4. Replace filter by aligning Hinge Tabs (F) and rotating into place until
latched into the Dirt Cup (C).
D
B
A
F
C
E
7.3