Verilux VH04WW1 - Manual (Page 25)

25
7. Care and Maintenance — continued
C
B
A
D
7.4 Sponge Filter
The Sponge Filter is located behind the HEPA-12 Pre-Filter attached to the Dirt Cup.
1. Access the Sponge Filter by first removing the HEPA-12 Pre-Filter.
2. Grasp Sponge Filter and remove.
3. Hold filter under cold running water to remove dirt. Squeeze filter to remove excess
water and allow to dry completely.
4. Replace filter into Dirt Cup with proper orientation.
Note: Assure the Sponge Filter and the HEPA-12 Pre-Filter are installed properly before replacing the Dirt Cup into the Canister.
7.5 HEPA-12 Exhaust Filter
The HEPA-12 Exhaust Filter (A) is located under the Filter Access
Panel (B) on the back of the canister.
1. Remove the the HEPA-12 Exhaust Filter (A) by lifting up on
the Access Panel Tabs (C).
2. Grasp the filter by the tab (D) and lift away from canister.
3. Gently tap the filter on the inside of a garbage receptacle to
remove excess dust and dirt.
4. Replace filter by first aligning filter’s rear edge inside the lip of
the recess and then rotate filter down flat into recess (E).
5. Replace Filter Access Panel (B) by first aligning capture tabs,
then pressing down on the two Access Panel Tabs (C) to
latch in place.
7.4
7.5
7.6 Replacement Filters
A Replacement Filter Kit is available for purchase. Please refer to the Replacement Part List in Table 7-1 on page 28.
E