Installing high/low beam headlight bulbs, Insert the new bulb in the headlight unit, Reconnect the connector and wiring – Volvo S40 User Manual
Page 120
2003 Volvo S40 & V40
Installing high/low beam headlight bulbs
●
Insert the new bulb in the headlight unit
●
Reconnect the connector and wiring.
●
Press the retaining spring over the connector/bulb until it clicks into position.
●
Reinstall the rubber cover at the rear of the headlight unit.
●
Put the hard plastic cover in place above the headlight housing and press the tab down to secure the
cover.
NOTE: Never touch the glass of a bulb with your fingers: this could leave traces of grease or oil on the
glass which then evaporate and may damage the reflector.
Side marker lamp replacement
Slide the lamp insert backward and pull out. Try to loosen the lamp insert with your fingers if possible.
Otherwise use a stiff piece of plastic or wood to protect the paint. Turn the bulb holder counter-
clockwise and pull out. Replace with a new bulb. Press in the bulb holder and twist clockwise. Reinstall
file:///K|/ownersdocs/2003/2003_SV40/03sv40_06a.htm (6 of 11)12/30/2006 4:16:11 PM