Volvo 960 - Manual (Page 127)

1996 Volvo 960
Pull the belt out far enough to insert the latch plate into the receptacle (buckle for rear seats) until a
distinct snapping sound is heard. The seat belt retractor is normally "unlocked" and you can move freely,
provided that the shoulder belt is not pulled out too far. The retractor will lock up as follows:
●
if the belt is pulled out rapidly
●
during braking and acceleration
●
if the vehicle is leaning excessively
●
when driving in turns
In order for the seat belt to provide maximum protection in the event of an accident, it must be worn
correctly. When wearing remember:
●
The belt should not be twisted or turned.
●
The lap belt must be positioned low on the hips (not pressing against the abdomen). Make sure that
the shoulder belt is rolled up into its retractor and that the shoulder and lap belts are taut.
Before exiting the car, check that the seat belt retracts fully after being unbuckled. If necessary, guide
the belt back into the retractor slot.
WARNING! Any device used to induce slack into the shoulder belt portion of the three-point belt
system will have a detrimental effect on the amount of protection available to you in the event of a
collision. The seat back should not be tilted too far back. The shoulder belt must be taut in order to
function properly.
pg. 3:3 Seat belts
file:///K|/ownersdocs/1996/1996_960/96960_301.htm (2 of 4)12/30/2006 10:12:52 AM