Wasp Bar Code W-600 - Manual (Page 14)

11
Chapter 1
Operator Controls
Operator Controls
Power Switch - Controls printer power
On - normal operation
Off - the power should be turned off before connecting or
disconnecting the communication cables and
power cables
Feed Button - Advances the media to the printing position
Press - to advance a label
Press - takes the printer out of a “pause” condition
Press and hold while turning on the power to print out the
configuration profile
Pause Button - Stops the printing process
Press - to resume printing process
Press - to perform media calibration
Cancel Button - Terminates the printing process
Press - to force printer to continue after an error
Press - to reset to factory defaults
LED Indicators
Ready - The Ready indicator is illuminated at all times
except:
1.The printer is in a PAUSE state
2. Error condition
Media - The Media indicator will remain on under normal
operating conditions except when blinking = out of media
Ribbon - The Ribbon indicator is illuminated under
thermal transfer mode with ribbon installed except when in
direct thermal mode with no ribbon installed
Blinking = out of ribbon