Wasp Bar Code W-600 - Manual (Page 19)

Troubleshooting
Normally, when the printer has an error, the “Ready” LED indicator will blink.
To understand the problem, please check LEDs first:
A. Ready and Media LEDs blink at the same time
Possible Solutions Refer to Pages
Problems
Mis-detected • Check the label path 10-14
the label gap. • Check the label sensor
Label stock • Reload labels 10-14
empty
Label stock • Reinstall the label roll 10-14
not installed
properly
Label jam • Check media path and 10-14
print head for possible
media errors
16
Chapter 5
Troubleshooting