Wasp Bar Code W-600 - Manual (Page 15)

12
Chapter 2
Resetting the Printer
Resetting the Printer to Factory
Default Settings
1. Turn off the printer. Press and hold the CANCEL button.
2. Turn on the printer.
3. When the message “E2PROM RESET...” is displayed on the LCD and READY
indicator blinks, release the button.
4. When the “Ready” message is displayed, the READY indicator will stop
blinking and light up.
5. The following parameters automatically reset:
• Label parameters
• Heat (Darkness)
• Speed
• Symbol set (language)
• Others for specific emulation
Note:
1. All settings are stored in non-volatile EPROM and cannot be erased when
the printer is turned off.
2. The DIP switch settings cannot be reset.
3. It is necessary to perform a label sensitivity calibration after resetting.
4. The printed label count cannot be reset.