Worth Data 5202D - Manual (Page 5)

Chapter 1
Installation
Components of 520-2D Reader
In the event the shipping box shows damage on arrival, please note the damage on the carrier's receipt log. Open
the box and inspect the contents for damage. If there is visible damage, or if the unit fails to work, contact us
with the details of the trouble; we will be happy to send you a replacement.
The contents of your 520-2D reader shipment should include the following:
1. An 520-2D reader with either USB or serial cable attached.
2. A scanner holder.
3. A Utilities CD-ROM with Manuals & Setup Menus in PDF Format.
• USB Interface (PC and Mac)
The 520-2D reader is attached directly to the USB port of the computer. The Windows® or Macintosh®
operating systems provide the software required to access the USB port. Data coming from the scanner through
the USB port appears as keyboard data in your application. No power supply is required for the USB interface.
Simply plug the USB cable into any available USB port on your PC or powered HUB and the 520-2D should power-
up and be ready to use in a few seconds. It is not recommended to use non-powered hubs due to the high power
requirements of the 520-2D.
• Serial Interface (T5000 TriCoder and T701 Terminal)
The 520-2D can be used as an external reader with the Worth Data T5000 series of TriCoders and T701 series of
RF Terminals. On the TriCoder, the input device will need to be modified to instruct the T5000 to power up the
520-2D reader and input data from the external reader. On the RF Terminal, the prompt will need to be modified
to power up the 520-2D and input data from the external reader. Refer to the T5000 and T701 manuals for
specific information.
1-1