Worth Data 5202D - Manual (Page 51)

Read Mode
Start Setup End Setup
,ZZ, ,ZZ,
Read Mode Settings:
Read Mode
single read default
,S0,
multiple read (see below)
,S1,
continuous read (used mainly for demonstration)
,S2,
In multiple read mode, when a bar code has been decoded, the decoded data will be output and the scan
engine will keep on reading. When the bar code that has just been output is read again, it will not be
output. However, when the scanner cannot decode any labels for some configurable time, it will forget
the previous scan and then the same label can be read again.
Multiple Read
Reset Time
multiple read reset time = 1 frame
,AH,
multiple read reset time = 2 frames
,AI,
multiple read reset time = 3 frames
,AJ,
multiple read reset time = 4 frames
,AK,
multiple read reset time = 5 frames
,AL,
multiple read reset time = 6 frames default
,AM,
multiple read reset time = 7 frames
,AN,
multiple read reset time = indefinitely
,AG,
Enable/Disable
Trigger
enable trigger default
,S8,
disable trigger (continuous read)
,S7,
A-45