Wegener Communications IPUMP 562 - Manual (Page 27)

www.wegener.com 800092-01 Rev. A 17
Unity 552 User’s Manual
Tune to a
carrier Carrier Settings screen
Use following steps to display Carrier Settings screen on the OSD menu:
1. Press any push-button on the front-panel to display the Main Menu .
2. Press the down arrow button to select Carrier Settings .
3. Press Enter .
4. View the details as shown in Figure 3.4 .
Figure 3.4: iPump 562 OSD Carrier Settings Screen
Notes:
The Status shall be displayed as Tracking OK if the unit is tuned to a carrier.
Valid values for DVB-S2 are 0.35, 0.25 and 0.20.
The LNB DC Power may be turned on or off.
The SNR Margin Warning may be set with a desired threshold value in dB.
Current Channel screen
Use following steps to display Current Channel screen on the OSD menu:
1. From the Carrier Settings screen, press the down arrow button to select Current
Channel .
2. Press Enter to display the Current Channel screen shown in Figure 3.5 .
3. To navigate the screen, use the down arrow and Enter buttons to select an option.
When the corresponding value of that option on the left is selected, use up or down
buttons to set to the desired setting. Press
Enter when done. Move to the next
option using up or down button or left arrow to exit to the previous menu level.