Wegener Communications IPUMP 562 - Manual (Page 31)

www.wegener.com 800092-01 Rev. A 21
Unity 552 User’s Manual
Table 3.5: Indicator Threshold screen options
Signal Strength Meter screen
Use following steps to display Signal Strength Meter screen on the OSD menu:
1. Press any push-button on the front-panel to display the Main Menu .
2. Press the down arrow button to select Carrier Settings .
3. Press Enter .
4. Press the down arrow button to select Signal Strength Meter .
5. Press Enter to view the screen as shown in Figure 3.9 .
Figure 3.9: iPump 562 OSD Signal Strength Meter Screen
Set Subtitling
options Subtitling Setup screen
Use following steps to display Subtitling Setup screen on the OSD menu:
1. Press any push-button on the front-panel to display the Main Menu .
2. Press the down arrow button to select Subtitling Setup .
3. Press Enter .
4. View the details as shown in Figure 3.10 .
Option Possible values Comments
Errored Secs per Min 10 to 19 Set the threshold for how many errors per
minutes before raising a warning condition.