Wayne-Dalton 8850 - Manual (Page 5)

5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Required
Removing an old Door
PR
e-
iNST
alla
Tio
N
SAfETY GLASSES
fLAT TIP SCREWDRIVER
1/4”, 3/8”, 7/16”, 1/2” &
9/16” WRENChES
7/16”, 1/2” &
9/16” SOCKET
PhILLIPS hEAD
SCREWDRIVER
RATChET WRENCh
POWER DRILL
SAWhORSE
GLOVES 3/8”, 7/16” SOCKET
DRIVER
hAMMER
VICE GRIPS
STEP LADDER
TAPE MEASURE LEVEL VICE CLAMPS
PENCIL
9/32”, 1/2”, 3/16” & 1/8”
DRILL BITS
Counterbalance spring tension must always be released before any attempt is made to start removing an existing door.
A POWERfUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR fATAL INjURY. TO AVOID
INjURY hAVE A TRAINED DOOR SYSTEMS TEChNICIAN, USING PROPER TOOLS AND INSTRUCTIONS, RELEASE ThE
SPRING TENSION.
for detailed information see supplemental instructions “removing an existing door/preparing the opening”. These instructions are
available at no charge from Wayne-Dalton Corp., P.O. Box 67, Mt hope, Oh 44660, or at www.wayne-dalton.com.
waRNiNg
APPROVED WINDING BARS 1/4” TORX BIT
P1