Wayne-Dalton 8850 - Manual (Page 7)

7
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
PR
e-
iNST
alla
Tio
N
Preparing the opening
continued......
wooD JambS
2” TRack
fLUSh
1-1/2”
2” X 6” jAMB IS
RECOMMENDED
1/2”- 5/8”
5/16 X 1-5/8”
LAG SCREW
4”
MIN.
SIDE ROOM
4-3/16”
wooD JambS
3” TRack
fLUSh
1”
2” X 6” jAMB
IS RECOMMENDED
1/2”- 5/8”
5/16 X 1-5/8”
LAG SCREW
5-1/2”
MIN.
SIDE ROOM
4-15/16”
installation
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and level
with header.
imPoRTaNT: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS (NOT SUPPLIED) MUST BE USED WhEN INSTALLING CENTER
BEARING BRACKETS, END BRACKETS, jAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS
ON TREATED LUMBER (PRESERVATIVE-TREATED). STAINLESS STEEL OR PT 2000 COATED LAG SCREWS ARE NOT NECESSARY WhEN
INSTALLING PRODUCTS ON UN-TREATED LUMBER.
imPoRTaNT: WhEN INSTALLING 5/16” DIAMETER LAG SCREWS USING AN ELECTRIC DRILL/DRIVER, ThE DRILL/DRIVER’S CLUTCh MUST
BE SET TO DELIVER NO MORE ThAN 200 IN. LBS. Of TORqUE. fASTENER fAILURE COULD OCCUR AT A hIGhER SETTING.
Note: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit, prior to fastening.
DRumS DimS
3” TRack, 15”
RaDiuS
2” TRack, 15”
RaDiuS
2” TRack,
12” RaDiuS
400-8 hEADROOM 15-1/2” 14-1/2” 12-1/2”
Note: for other drums, mounting conditions, lifts, and options,
consult your Wayne-Dalton representative.
heaDRoom chaRT For Standard lift Track (minimum Distance Required)
TRack
SiZe
DePTh
iNTo Room SiDeRoom
2”
DOOR hEIGhT
PLUS 18”
If TROLLEY
PLUS 66”
4”
3”
DOOR hEIGhT
PLUS 24”
If TROLLEY
PLUS 66”
5-1/2”
backRoom chaRT & SiDeRoom chaRT
WEAThER
SEAL
jAMB 1/8” TO 1/4”
WEAThER
SEAL
WALLANGLE
(ANGLE MOUNT)
USED fOR CONTINUOUS WALL ANGLE TRACK
USED fOR BRACKET MOUNT TRACK