Walker IMPLEMENT HITCH SB6670 - Manual (Page 37)

Assembly Instructions
33
CHECK BROOM ANGLE ADJUSTMENT
Refer to Angle Adjustment Lever in Operating In-
structions.
CHECK DRIVE CHAIN
Refer to LUBRICATION for Rotary Broom Drive
Chain in
Maintenance Instructions .
Refer to ADJUSTMENTS of Rotary Broom Drive
Chain Tension in
Maintenance Instructions .
CHECK GEARBOX
Refer to LUBRICATION for Rotary Broom Gear-
box in
Maintenance Instructions .
CHECK SIDE TO SIDE LEVEL ADJUSTMENT
Refer to ADJUSTMENTS of Rotary Broom Brush
Leveling in
Maintenance Instructions.
CHECK BRUSH TO GROUND CONTACT
PRESSURE ADJUSTMENT
Refer to Ground Contact Knob in Operating In-
structions.
Two-Stage Snowblower
CHECK CUTTING EDGE
•
Make sure the cutting edge is not nicked, bent
or worn.
Refer to REPLACING/REPAIRING of Two-Stage
Snowblower Cutting Edge in
Maintenance Instruc-
tions.
CHECK AUGER
•
Make sure the auger is clear of snow and/or
ice.
•
Make sure the auger is free to rotate.
•
Check that the auger flighting and paddle
blades are in good condition and not bent.
CHECK CHUTE AND DEFLECTOR
•
Make sure the chute and deflector are not
clogged with snow and/or ice.
•
Turn the chute rotation handle and rotate the
chute. The chute should rotate freely.
•
Use the deflector position control knobs and
raise and lower the deflector. The deflector
should move freely.
CHECK GEARBOX
Refer to LUBRICATION for Two-Stage Snowblow-
er Gearbox in
Maintenance Instructions .
CHECK REDUCTION CHAIN
Refer to LUBRICATION for Two-Stage Snowblow-
er Reduction Chain in
Maintenance Instructions .
Refer to ADJUSTMENTS for Two-Stage Snow-
blower Reduction Chain Tension in
Maintenance
Instructions .
Debris Blower
CHECK CHUTE AND DEFLECTOR
•
Make sure the chute and deflector are not
clogged with leaves and/or debris.
•
Turn the chute rotation handle and rotate the
chute. The chute should rotate freely.
•
Use the deflector position control knob and
raise and lower the deflector. The deflector
should move freely.
CHECK GAUGE WHEEL TIRE PRESSURE
•
Make sure the tire pressure is 20 PSI (137 kPa).
INSPECT DRIVE BELT
Refer to ADJUSTMENTS of Debris Blower Drive
Belt Tension in
Maintenance Instructions.
CHECK BLOWER FAN
•
Make sure the fan is clear of debris.
•
Make sure the fan is free to rotate.
•
Check that the fan blades are in good condition
and not bent.