Walker IMPLEMENT HITCH SB6670 - Manual (Page 69)

Removal and Storage Instructions
69
Detach Rotary Broom from Implement Hitch
Two-Stage Snowblower
1. Park the tractor on a level surface and lower the
snowblower.
2. Remove the hairpin from the parallel bar at the
adaptor end, and remove the parallel bar from
the implement adaptor.
3. Disconnect the driveline from the tractor PTO
shaft.
4. Remove the linchpin from the quick hitch latch
and place the hitch locking lever in the UN-
LOCKED position.
5. Start the tractor engine and carefully back the
tractor away from the snowblower.
Detach Snowblower from Implement Hitch
Debris Blower
1. Park the tractor on a level surface and lower the
debris blower.
2. Set the parking stands in the most extended po-
sition and lock in place.
3. Disconnect the tractor PTO shaft from the de-
bris blower input shaft.
4. Remove the linchpin from the quick hitch latch
and place the hitch locking lever in the UN-
LOCKED position.
5. Start the tractor engine and carefully back the
tractor away from the debris blower.
WARNING
DO NOT attempt to remove the snow-
blower with the tractor engine running.
Disengage the PTO clutch, stop the en-
gine and remove the ignition key. Wait for
all movement to stop before getting off the
seat.
To prevent accidental engine starting, dis-
connect the fuel solenoid wire [diesel en-
gines] or the spark plug wire(s) [gasoline
engines].
PTO Shaft
Welded Sleeve
Hairpin
Pivot
Lock Pin
Quick Hitch
Lever
WARNING
DO NOT attempt to remove the debris
blower with the tractor engine running.
Disengage the PTO clutch, stop the en-
gine and remove the ignition key. Wait for
all movement to stop before getting off the
seat.
To prevent accidental engine starting, dis-
connect the fuel solenoid wire [diesel en-
gines] or the spark plug wire(s) [gasoline
engines].
PTO Shaft
Hitch Locking
Lever