Welch Allyn SCANTEAM 3400PDF - Manual (Page 11)

1–3 SCANTEAM 3400PDF User’s Guide
Connecting the Scanner
Install the scanner by following the steps shown below:
➊ Turn off the power to the host system.
➋ Connect the interface cable to the scanner and to the terminal/computer.
Keyboard Wedge Interface Example
Disconnect
1
2
3
➌ Turn on the power to the host system.
➍ Program your scanner to work with your terminalor computer by scanning
the Terminal Set-Up Codes. Either scan the Plug and Play codes (Page
1-7) or use the Supported Terminallist (Pages 1-9) to determine your
terminal's Terminal ID.
With Plug and Play programming, you connect the scanner and scan only one
bar code and required prefixes and suffixes to program the scanner to work
with a designated interface.
➎ To determine if your scanner is set up correctly, scan one of the sample bar
codes on the back cover of this guide.
(Cable, Keyboard, and Terminal will vary.)