Winegard WB-2000 - Manual (Page 28)

6
To reset the Satellite Receiver, press and hold the Power button on the Receiver (not on the
remote control). The receiver will reset, and after a few moments will automatically restart.
It may take up to 5 minutes for some receivers to restart.
After the receiver reboots, the new Guide will download, and the programming on the new
satellite will be available. You must repeat this process each time you manually change
satellites for Dish Network or Bell ExpressVU.
Returning to Automatic Mode
The antenna will remain in Manual Mode until a Service Provider is chosen to put the
antenna back into Automatic Mode. See the operating section for your service provider for
instructions on choosing your service provider.
To Operate in Manual Mode
From the Main Menu, press [ENTER] to confirm Satellite Setup.
Press [SELECT] to select Manual Mode.
Press [ENTER] to confirm.
Press [SELECT] to cycle through the available satellites.
When you have selected your desired satellite, press [ENTER]. A Confirmation screen will
appear, and you will be prompted to Save Changes.
Press [SELECT] to select YES.
Press [ENTER] to confirm.
The Satellite Interface will reset, and the satellite antenna will begin its search routine for
the selected satellite. After acquisition, you will be able to watch television on the selected
satellite.
Satellite Interface
POWER SELECT ENTER
Manual Mode*
Factory Default
Satellite Interface
POWER SELECT ENTER
Satellite Setup*
Sleep Menu
Satellite Interface
POWER SELECT ENTER
Sat: 61.5
72.5