Winegard WB-2000 - Manual (Page 29)

7
Factory Default
If you determine that your satellite antenna is not functioning as expected, you may want to
return your system to factory default and run the satellite setup again.
From the Main Menu, press [ENTER] to confirm Satellite Setup.
Press [SELECT] 2 times to select Factory Default.
Press [ENTER] to confirm.
A confirmation will appear. Press [SELECT] to select Yes, then press [ENTER] to con-
firm. A confirmation message will appear, and the Satellite Interface will reset. You should
now repeat satellite setup.
7.3 Sleep Menu
The Sleep Menu is applicable for in-motion systems only. The Sleep Menu will have no
effect on stationary only systems.
An in-motion satellite system has two modes, Tracking Mode and Sleep Mode. In Track-
ing Mode, the satellite antenna is actively following the satellite. If the antenna senses RV
movement, it will move along with the RV. The antenna will automatically enter Sleep
Mode if it does not sense movement in the RV for 7 minutes. In sleep mode, the antenna
remains motionless on the satellite signal.
Sleep Menu options flow in the following order:
Enter Sleep → Exit Sleep Mode → Set Sleep Time → Default Sleep → Exit
From the Main Menu, press [SELECT] to select Sleep Menu.
Press [ENTER] to confirm.
Enter Sleep
You may force the antenna into Sleep Mode at any time while the system is in Tracking
Mode.
From the Sleep Menu, press [ENTER] to confirm Enter Sleep.
A confirmation message will appear. The antenna will immediately exit Tracking Mode
and enter Sleep Mode.
Satellite Interface
POWER SELECT ENTER
Factory Default*
Exit
Satellite Interface
POWER SELECT ENTER
Sleep Menu*
Diagnostics
Satellite Interface
POWER SELECT ENTER
Sleep Menu*
Exit Sleep Mode