WiebeTech SS8 - Manual (Page 11)

W i e b e T e c h L L C
3.4 LCM (LCD Control Module)
The LCM is found on the bottom side of the ProSATA. It has four buttons for
controlling functions:
c(up), d(down), ENT (Enter), and ESC (Escape).
c and d are pressed to scroll through the functions and options.
ENT is pressed to enter functions and to accept selections.
ESC is used to exit to previous menu. Holding ESC will jump back to main menu.
After the system boots up, the following screen will be shown on the LCM:
WiebeTech
(IP address)
↵
There are 6 functions accessible by the LCM: Alarm Mute, Reset/Shutdown,
Quick Install, View IP Setting, Change IP Config, and Reset to Default.
Alarm Mute
Select Alarm Mute to mute the alarm.
Reset/Shutdown
Select Reset to restart the controller without powering
down.
Select Shutdown to prepare controller for shutdown prior
to powering off.
Before powering off system, it is recommended to do
Shutdown from the controller to clear the data from
cache.
Quick Install
Select Quick Install to setup a RAID array from the
available drives. Please see Appendix for RAID level
definitions and minimum requirements for each RAID
level.
View IP Setting
Select View IP Setting to display current IP address, IP
subnet mask, and IP Gateway.
Change IP Config
Select Change IP Config to modify IP address, IP subnet
mask, and IP Gateway.
Reset to Default
Select Reset to Default to reset to original manufacture
settings. The login and password will return to default:
admin:1234, and the IP address to default: 192.168.0.1
ProSATA SS8 User Manual
- 11 -