WiebeTech SS8 - Manual (Page 31)

W i e b e T e c h L L C
5.2 Create user data volume
To create a user data volume (UDV), please follow these procedures.
Figure 5.2.1
1. Enter
Volume config
.
2. Enter
User data volume
.
3. Click .
4. Enter a name for this UDV. Select which VG this UDV will be created
from. Select the CV no. if a dedicated CV has been created (Global CV
will be used as default). Set the capacity to be used for the UDV. Set
the desired stripe height, block size, on/off line status, read/write mode
and priority. Click after making sure all configurations are
set correctly.
5. Done. A summary page will be created to show the new UDV.
Note
If a dedicated cache volume is needed for UDVs, the cache volume
will have to be created prior the UDV setup. More detail is in section
5.4
ProSATA SS8 User Manual
- 31 -