WiebeTech SS8 User Manual
Page 33
W i e b e T e c h L L C
1. Select which UDV to attach.
2. Choose Bus ID, SCSI ID and LUN to attach, and then click
.
3. Done.
Note
Note which channel the SCSI cable is connected to. The SCSI ID of
the UDV must correspond to the SCSI channel and cable setup.
5.3.2 Detach Bus ID, SCSI ID and LUN from UDV
To detach IDs and LUN from the UDV, please follow the procedures below.
Figure 5.3.2.1
1. Enter
Volume config
.
2. Enter
Logical unit
.
3. Select the UDV by checking the square for the appropriate UDV.
Click
.
4. A dialog window will pop up for confirmation. Choose
.
5. Done.
Note
If you delete a UDV with attached IDs and LUN from the user data volume
page, it will detach the IDs and LUN automatically.
ProSATA SS8 User Manual
- 33 -