Waves Multimaximizer L3-LL - Manual (Page 15)

L3-LL User Manual
15
Band Controls
he Band Controls section features controls over the Crossover network which splits the input into
r displaying the
put level.
Se
r
- R g
- Defau
g
less overlap between the bands.
Crossove
Just below t
L3-LL. Eac
e
Each of the
LOW Range:
O MID Range: 150Hz to 300Hz. Default to 320Hz.
I MID Range: 1000Hz to 5000Hz. Default to 1278Hz.
I Range: 3kHz to 11kHz. Default to 5113Hz.
er Band Solo
Solo the frequency band to adjust the frequency bandwidth. Solo outputs the signal post the crossovers
and pre the dynamic process.
T
Frequency Bands. Each Band has controls for Solo, Gain, Priority, Release, and a Mete
in
pa ation
an e 0 to 100
lt 100
Separation is similar to a filter cutoff slope (or Q) between the bands’ sidechain being fed to the
PLMixer™. At low Separation settings, crossover slopes between bands are moderate, creating more
overlap between the bands. At higher Separation settings, the crossover slopes are steeper, resultin
in
r (Xover) Controls
he graph are the Crossover frequency adjustment controls. There are 4 Crossovers in the
h s ts the cutoff frequencies for the corresponding High Pass and Low Pass filters.
four Crossovers has a unique range of frequencies, as follows:
20Hz to 350Hz. Default to 80Hz.
L
H W
H
P